Frame Nailer, 30-Degree, (Tool Only) Seats Single-Cut On Sides & Edges

Single-Cut On Sides & Edges

It has been engineered with the safety behind the narrow nosepiece and a short center height to allow for nail placement in hard-to-reach areas and into tight corners

LOAD RATING CLASS: III INTERCHANGEABLE BALL: NO MATERIAL: STEEL HEAT HARDENED: YES

3/4" & 1" deburring tool and depth gauge all in one

THHN wire used throughout

Frame Nailer, 30-Degree, (Tool Only) Seats Single-Cut On Sides & EdgesDeWalt 20volt, 30 degree frame nailer, paper tape, (bare tool use with air compressor). 2" to 3 1 2" capacity, engine design allows consistent nail penetration into both soft & hard joints, sequential operating mode allows for precision placement, bump operating mode provides the user with production speed, 6 position dial allows the user to move between applications, top cap is impact resistant & easy to remove for troubleshooting, easy access to the