Terminator Underbody Pivot Casting useownbox or bolt & nut tarp

or bolt & nut tarp installation

Excellent Airflow – The breathable mesh design prevents wind resistance while keeping your load secure

Replacement aluminum end foot cap for rear pull bar of pull-style hand crank manual tarp systems

dozers or even Trackhoes

The width and height of the elbow are 2" and 1-3/16"

Terminator Underbody Pivot Casting useownbox or bolt & nut tarpTerminator Underbody Pivot Casting. This casting is required to attach a Terminator arm to a single coil style or 10 spring style Underbody Spring. The casting has a square end that slides onto the shaft of a Underbody spring, the other end will slide inside of the Terminator Arm. The casting is pre drilled for a bolt on the spring end and two holes for the arm end.