Scotts Damper Arm Puller Tool SALE tibial and tendon back plate

tibial and tendon back plate replacement EVA foam pads

This SUB Mount allows you to run the bars in two positions: 10mm or 20mm in front of the steering stem

It works with most of the handlebar switches out there but if you want to be ready to race you can purchase either the single or dual RNS Multiswitch

risers are optional

Note: You must retain the original spacers from your plastic backing plate and insert them into this mounting plate to complete the assembly

Scotts Damper Arm Puller Tool SALE tibial and tendon back plateThe Link Arm Puller, also known as Arm Remover tool, allows you to remove the link arm without damage to the seal area on the bottom of the stabilizer. This puller is also essential for those of you who plan to service your stabilizer yourselves. Note: If the damper arm nut has been installed with permanent thread lock compound (usually red), it may require some heat to loosen the compound. Apply thread lock when reinstalling the nut. Do not over