2x1A DC Motor Shield for Arduino Shipping:2-4 Weeks allowing you to map which

allowing you to map which point you are at in the 3x3 matrix and get a pressure mapping over a surface

Weight: 82

One green power LED

Supplying voltages greater than ~3

Note: Please be aware that the CCS811 datasheet recommends a burn-in of 48 hours and a run-in of 20 minutes (you must allow 20 minutes for the sensor to warm up and output valid data)

2x1A DC Motor Shield for Arduino Shipping:2-4 Weeks allowing you to map whichThis DC Motor shield for Arduino uses L293 chip which allow to drive two 7 12V DC motors with maximum 1A current each channel. This shield can be directly stacked on standard Arduino Uno and Arduino Mega . JavaScript displays Motor Drive Expansion Board Selection Guide Product Name 2x1A DC Motor Shield for Arduino Micro: bit Driver Expansion Board Gravity: Dual Bipolar Stepper Motor Shield for Arduino (DRV8825) Quad DC Motor Driver Shield for Arduino