VClamp for RoboClaw or MCP Controllers SF_Misc. Dev Tools 1″ × 0

1″ × 0

This versatility

double resistors

The ATMega328 comes with demo code that gives a temperature readout in degrees F at 38400bps

56-MHz Crystal

VClamp for RoboClaw or MCP Controllers SF_Misc. Dev Tools 1″ × 0The VClamp allows RoboClaw and MCP motor controllers to be used with switching power supplies by dissipating excess regenerative energy through a connected external resistor (not included). The VClamp connects directly to the motor power supply and gets logic power and signals from the RoboClaw or MCP controller. The clamping voltage is set in the Basicmicro Motion Studio software, and the board can handle peak voltages and currents up to 60 V and 60