EasyDriver - Stepper Motor Driver Shipping:2-4 Weeks The load should be connected

The load should be connected across OUT and GND and should draw no more than 2 A

6 x 12-bit analog inputs

**Note:** This is not a direct replacement for the [SparkFun Power Cell](https://www

com/sparkfun/SparkFun_BME280_Arduino_Library)

The default

EasyDriver - Stepper Motor Driver Shipping:2-4 Weeks The load should be connectedThe EasyDriver is a simple to use stepper motor driver, compatible with anything that can output a digital 0 to 5V pulse (or 0 to 3. 3V pulse if you solder SJ2 closed on the EasyDriver). The EasyDriver requires a 6V to 30V supply to power the motor and can power any voltage of stepper motor. The EasyDriver has an on board voltage regulator for the digital interface that can be set to 5V or 3. 3V. Connect a 4 wire stepper motor and a microcontroller