the olsson block Ultimaker 2 / 2+ Using professional power chip

Using professional power chip

This is the Ultimaker 2+ TFM Teflon coupler

We recommend slower printing on bridges

The filament does not emit any toxins

If you can still see the melt break when printing a bridge

the olsson block Ultimaker 2 / 2+ Using professional power chipThis is the Custom Heater Block by Mr Anders Olsson, discussed at large in this thread in the Ultimaker forum. Installing it lets you change nozzles on the Ultimaker 2 in less than 20 seconds. This is the Custom Heater Block by Mr Anders Olsson, discussed at large in this thread in the Ultimaker forum. Installing it lets you change nozzles on the Ultimaker 2 in less than 20 seconds. The Olsson Block ships with one JET 0. 25JET 0. 40JET 0. 80 nozzle